Shape Rolling

Sumário:

Shape rolling of steels is a process which requires a lot of heat and a lot of force. Reheating is carried out to around 1200°C and then the metal is continuously fed through rollers to draw the desired dimensions.
Popular shapes have good application in the construction business as I, H, and U shaped beams or girders can be produced for structural integrity.

Steel is a strong material that is highly resistant to shaping at normal temperatures but this resistance lessens considerably at higher temperatures. For that reason the billets, blooms and slabs from the steelmaking process are shaped into basic products at carefully controlled elevated temperatures.

The method that is most commonly used for shaping is to heat the steel to around 1,200°C in a reheat furnace and roll the steel, squeezing it between sets of cylinders or rolls. Rolls are arranged in pairs and housed in a 'stand'.

To change the shape of a material as strong as steel the rolls must exert forces measured in thousands of tones, and must also draw the steel continuously through the rolls while reducing the thickness. Two main classes of product are produced – flat products, sheets or strips of uniform thickness, and long products - lengths of a particular cross section, ranging from rectangular bars to double flange H sections. For flat products, two horizontal rolls are set one above the other in an open housing.

For long products, a series of specially shaped and angled rolls (referred to as stands) are used to transform the section to the required shape. The figure shows the stand used to create open sections.

British, European and International standards define dimensions for a wide variety of open section shapes, notably I and H shaped sections, angle sections and channels.



Figure 1: Standard open sections

In shape rolling, the work is deformed into a contoured cross section. Products made by shape rolling include construction shapes such as I-beam, L-beam, and U-channels; rail for railroad tracks; and round and square bars and rods. The process is accomplished by passing the work through rolls that have the reverse of the desired shape.

In the form of illustration, the stages in shape rolling of an H-section part can be seen in Figure 2.



Figure 2: Stages in the H-section shape rolling

Procurar conhecimento básico

Colocar uma frase para procurar por:

Procurar por

Texto completo
Palavras chaves

Títulos
Resumo

Diagramas de tratamento térmico estão disponíveis para um grande número de matérias no banco de dados da Total Materia.

Diagramas de tratamento térmico abrangendo temperabilidade têmpera dureza, TTT e CCT podem ser encontrados no conjunto de dados padrão.

Para selecionar materiais por propriedades especiais, você pode usar as caixas de seleção especiais de busca no módulo de Pesquisa Avançada.

Para definir os critérios de pesquisa, tudo que você tem a fazer é selecionar o país / padrão do seu interesse a partir do "País / Standard 'lista pop-up e para a caixa de verificação' Diagrama de Tratamento Térmico", situado na área de Pesquisa Especial do formar-se na parte inferior da página de pesquisa avançada.

Clique em Enviar.


Depois de selecionar o material de seu interesse, clique no link Tratamento Térmico para visualizar os dados para o material selecionado. O número de registos de tratamento térmico é apresentado entre parêntesis ao lado da ligação.


Todas as informações disponíveis de tratamento de calor será exibida para o material escolhido.






Para você é uma oportunidade de fazer um test drive na Total Materia, nós convidamos você a participar de uma comunidade de mais de 150.000 usuários registrados através da Total Materia Free Trial.