UNI G-AlSi5CuMg Aluminium Alloys
Data updates
This material has 245 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI G-AlSi5CuMg Chemical Composition
UNI SPERIMENTALE 3600: 1955 / Primary aluminium-silicon-copper- magnesium alloy for castings (Si 5%, Cu 1.3%, Mg 0.5%)
Looking for full material performance data?
Free registration required • Instant access
UNI G-AlSi5CuMg Physical Properties
Temperature
This material has 245 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI G-AlSi5CuMg Heat Treatments
- R: Annealing at 350 - 390°C for 4 - 8 hours. T: Tempering in hot water from 510 - 530°C after preheating for at least 12 hours for sand castings and 8 hours for permanent mould castings. A: Artificial ageing at 150 - 160°C for 4 hours (A 15,5/4) or 8 hours (A 15,5/8) at 165 - 175°C, for 16 hours (A 15,17/16), depending on the required mechanical properties.
UNI G-AlSi5CuMg Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI G-AlSi5CuMg International Equivalent Materials
Showing 15 of 111 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 111 international equivalents?
See all 111 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 111Cross References
- 11Composition
- 18Mechanical Properties
- 12Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 6Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 86Total Suppliers