PROPRIETARY VP20ISO Tool steels
Data updates
This material has 155 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VP20ISO Chemical Composition
Villares Metals, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY VP20ISO Physical Properties
Temperature
This material has 155 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VP20ISO Heat Treatments
- Annealing: Heating slowly to temperature between 760/800°C (100°C/h) for 1 hour, followed by slow cooling at 30°C per hour until 600°C and, then, by air cooling. In this treatment, the use of protective atmosphere is important to avoid surface oxidation and decarburization.
Stress relieving:The indicated procedure is slow heating (100°C/h) up to 530°C, keeping 0.5 hour in temperature for each 25 mm of the largest section in the part; regardless of the section, the time must not be less than 2 hours. After relief, cool in calm air.
Quenching and Tempering: Heat slowly and uniformly at (100°C/h) up to 400°C and then at a maximum of 300°C/h until the austenitization temperature, between 840 and 860°C. Keep at temperature until complete homogenization of the entire piece. Cooling must be carried out in oil suitable for quenching, stirred and heated between 40 and 70°C, until the mold temperature reaches 100°C. Then cool in calm air between 50 and 70°C. The tools must be tempered immediately after hardening, as soon as they reach 60°C. Make at least 2 tempers and between each temper the parts must cool slowly to room temperature. The tempering temperature must be chosen according to the desired hardness. The time of each tempering must be at least 2 hours. For pieces larger than 70 mm, the time must be calculated as a function of their dimension. Allow 1 hour for each inch of thickness.
Nitriding: It must be carried out after quenching and tempering, as long as the nitriding temperature is at least 50°C lower than the temperature of the last tempering.
PROPRIETARY VP20ISO Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY VP20ISO International Equivalent Materials
Showing 15 of 71 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 71 international equivalents?
See all 71 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 71Cross References
- 5Composition
- 1Mechanical Properties
- 7Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 67Total Suppliers