PROPRIETARY Micro-Melt 23 Alloy 工具钢
材料组别:
黑色金属 / 工具钢
国家与地区/标准:
PROPRIETARY
数据更新
最新更新: 2022-02
更新总数: 1
更新历史
PROPRIETARY Micro-Melt 23 Alloy 化学成分
化学元素
数值
单位
CAS 编号
化学元素
C
数值
1.30
单位
%
CAS 编号
7440-44-0
化学元素
Cr
数值
4.20
单位
%
CAS 编号
7440-47-3
化学元素
Fe
数值
余量
单位
%
CAS 编号
7439-89-6
Carpenter Technology Corporation, Product Data Sheets,
需要完整的材料性能数据吗？
查看完整材料数据 ›
需要注册 • 立即访问
需要注册 • 立即访问
PROPRIETARY Micro-Melt 23 Alloy 物理性能
PROPRIETARY Micro-Melt 23 Alloy 热处理
- Annealing: heat slowly to 849/899°C (1560/1650°F), hold until the entire mass is heated through, and cool slowly (do not exceed 11°C [20°F] per hour) in the furnace to about 699°C (1290°F), after which the cooling rate may be increased. The annealed hardness should be maximum BHN 260 (HRC 26).
Hardening: preheat at 449/499°C (840°F/930°F), transfer to a second preheat at 849/899°C (1560/1650°F). Austenitize at 1093/1190°C (2000/2175°F), depending upon final hardness/toughness combination desired. When hardening in vacuum, the austenitizing temperature should be raised approximately 11/14°C (20/25°F) above that used for a salt bath. For oil quenching, an interrupted quench is recommended. Parts should be oil quenched to approximately 538°C (1000°F), removed from the bath, and air cooled. Similarly, parts may be quenched into a salt bath held at 538°C (1000°F), equalized, and air cooled. Vacuum furnaces with positive pressure quench capability can also be used. Parts should be allowed to cool to below 66°C (150°F) prior to tempering.
Stress Relieving: to relieve the stresses of machining, heat slowly to 599/699°C (1110/1290°F), hold 2 hours, furnace cool to about 500°C (930°F), then cool in still air. Tempering: the tempering temperature may be varied according to the desired hardness, but is usually in the range 538/579°C (1000/1075°F).
根据您的应用场景优化材料选择 - 预约演示
- 2交叉引用
- 8化学成分
- -机械性能
- 10物理性能
- 1热处理
- -金相组织
- -切削加工性能
- -应力-应变
- -成形性能
- -疲劳
- -断裂
- -爬行
- -焊接接头
- -涂层
- -尺寸
- -摩擦学
- -腐蚀
- -老化
- -耐候性
- -辐照
- 1供应商总数