PROPRIETARY Stavax Supreme Tool steels
Data updates
This material has 442 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Stavax Supreme Physical Properties
Temperature
This material has 442 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Stavax Supreme Heat Treatments
- Soft annealing: heat through to 740°C, then cool in the furnace at 15°C per hour to 550°C, then freely in air. Stress relieving: After rough machining the tool should be heated through to 650°C, holding time 2 h. Cool slowly to 500°C, then freely in air. Preheating temperature: 600 - 920°C. Normally a minimum of two preheating steps. Austenitizing temperature: 1000 - 1025°C but usually 1020°C. For very large moulds 1000°C is recommended. Temper minimum twice with intermediate cooling to room temperature. Lowest tempering temperature 250°C. Holding time at temperature minimum 2 h. Quenching media: Vacuum, cooling in gas with sufficient overpressure. Fluidized bed or salt bath at 350 - 500°C then cool in air blast.
PROPRIETARY Stavax Supreme Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Stavax Supreme International Equivalent Materials
Showing 15 of 225 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 225 international equivalents?
See all 225 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 225Cross References
- -Composition
- 7Mechanical Properties
- 12Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 1Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 193Total Suppliers