PROPRIETARY VND Tool steels
Data updates
This material has 151 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VND Chemical Composition
Aços Inajá Ltda, Product Data Sheet,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY VND Physical Properties
Temperature
This material has 151 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VND Heat Treatments
- Stress Relief: Relief temperature should be between 500 and 600°C, heating should be slow, as well as cooling inside the oven to 200°C.
Quenching: The heat for quenching should be between 790 and 820°C.
It is recommended to pre-warm the tools.
Cool in:
- Appropriate oil, with agitation and heated between 40 and 70°C.
-Molten salt bath, kept between 180 and 230°C.
- Calm air.
It cannot be vacuum quenched.
Tempering: The tools must be tempered immediately after tempering, as soon as they reach 60°C. Make at least 2 tempers and between each temper the parts must cool down to room temperature. Tempering temperatures should be chosen depending on the desired hardness. The time of each tempering must be at least 2 hours. For pieces larger than 70 mm, the time must be calculated as a function of their dimension. Allow 1 hour for each inch of thickness.
PROPRIETARY VND Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY VND International Equivalent Materials
Showing 15 of 66 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 66 international equivalents?
See all 66 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 66Cross References
- 13Composition
- 1Mechanical Properties
- 6Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 63Total Suppliers