ASTM A 209 Grade T1a Structural and constructional steels
Data updates
This material has 138 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 209 Grade T1a Chemical Composition
A209/A209M: 2003 / Standard Specification for Seamless Carbon-Molybdenum Alloy-Steel Boiler and Superheater Tubes
Looking for full material performance data?
Free registration required • Instant access
ASTM A 209 Grade T1a Physical Properties
Temperature
This material has 138 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 209 Grade T1a Heat Treatments
- Hot-finished tubes shall be heat treated at a temperature of 650°C (1200°F) or higher. Cold-finished tubes shall, after the final cold finishing, be heat treated at a temperature of 650°C (1200°F) or higher, or tubing may be furnished in the full-annealed, isothermal annealed, or normalized and tempered condition. If furnished in the normalized and tempered condition, the minimum tempering temperature shall be 650°C (1200°F).
ASTM A 209 Grade T1a Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 209 Grade T1a International Equivalent Materials
Showing 15 of 64 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 64 international equivalents?
See all 64 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 64Cross References
- 6Composition
- 5Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 6Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 53Total Suppliers