AFNOR NF X17CrNi16-2 Stainless steels
Data updates
This material has 1005 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
AFNOR NF X17CrNi16-2 Chemical Composition
EN 10088-3: 2023 / Stainless steels - Part 3: Technical delivery conditions for semi-finished products, bars, rods, wire, sections and bright products of corrosion resistant steels for general purposes
Looking for full material performance data?
Free registration required • Instant access
AFNOR NF X17CrNi16-2 Physical Properties
Temperature
This material has 1005 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
AFNOR NF X17CrNi16-2 Heat Treatments
- A: Annealed at 600-800°C, furnace or air cooled.
QT800: Quenched at 1020-1080°C, oil cooled. Tempered at (580-630°C) + (550-650°C).
QT900: Quenched at 1020-1080°C, oil cooled. Tempered at (540-600°C) + (520-640°C). - Hot forming: 1100-800°C, slow cooling; Annealing (+A) (Double annealing might be advisable): 680-800°C, air or furnace cooling; Quenching (+QT800): 950-1050°C, oil or air cooling; (If heat treatment is carried out in a continuous furnace, the upper part of the range specified should usually be preferred, or even exceeded); Tempering: 750-800°C + 650-700°C (In the case that the nickel is at the lower side of the range specified, a single tempering at 620 to 720°C may be sufficient); Quenching (+QT900): 950-1050°C, oil or air cooling; (If heat treatment is carried out in a continuous furnace, the upper part of the range specified should usually be preferred, or even exceeded); Tempering: 600-650°C.
AFNOR NF X17CrNi16-2 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
AFNOR NF X17CrNi16-2 International Equivalent Materials
Showing 15 of 378 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 378 international equivalents?
See all 378 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 378Cross References
- 42Composition
- 187Mechanical Properties
- 52Physical Properties
- 8Heat Treatment
- -Metallography
- -Machinability
- 34Stress-Strain
- 8Formability
- -Fatigue
- -Fracture
- -Creep
- 2Joints
- -Coatings
- 13Dimensions
- -Tribology
- 13Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 268Total Suppliers