PROPRIETARY CPM 154 Tool steels
Data updates
This material has 25 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CPM 154 Chemical Composition
Crucible Industries LLC., Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CPM 154 Physical Properties
Temperature
This material has 25 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CPM 154 Heat Treatments
- Annealing: Heat to 900°C, hold 2 hrs., slow cool no faster than 15°C per hour to 650°C, then furnace cool or cool in still air to room temperature. It can be cycle annealed by heating to 900°C. hold 2 hours, cool to 704°C, hold 4 hours, then air cool. Stress Relieved: Annealed Parts: Heat to 595-705°C, hold 2 hours, then furnace cool or cool in still air; Hardened Parts: Heat to 15-30°C below the original tempered temperature, hold 2 hours, then furnace cool or cool in still air. Hardened: Preheat: Heat to 760°C Equalize; Austenitize: 1037-1093°C, hold time at temperature 30-60 minutes; Quench: Oil or positive pressure (4 bar minimum) to below 50°C, or salt quench to about 540°C, then air cool to below 50°C. Salt bath treatment, if practical, will ensure the maximum attainable toughness for a given hardened treatment; Temper: Twice at 204-650°C, 2 hours minimum each time.
PROPRIETARY CPM 154 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CPM 154 International Equivalent Materials
Showing 2 of 2 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 2 international equivalents?
See all 2 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 2Cross References
- 3Composition
- 6Mechanical Properties
- 10Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers