PROPRIETARY CRUCIBLE 154 CM Tool steels
Data updates
This material has 29 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CRUCIBLE 154 CM Chemical Composition
Crucible Industries LLC., Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CRUCIBLE 154 CM Physical Properties
Temperature
This material has 29 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CRUCIBLE 154 CM Heat Treatments
- Annealed: Heat to 1650°F (900°C), hold 2 hours, slow cool no faster than 25°F (14°C) per hour to 1200°F (650°C), then furnace cool or cool in still air to room temperature. Can be cycle annealed by heating to 1600°F (900°C). hold 2 hours, cool to 1300°F (704°C), hold 4 hours, then air cool. Stress relived: Annealed Parts: Heat to 1100-1300°F (595-705°C), hold 2 hours, then furnace cool or cool in still air. Hardened Parts: Heat to 25-50°F (15-30°C) below the original tempering temperature, hold 2 hours, then furnace cool or cool in still air. Hardened: Preheat: Heat to 1400°F (760°C) Equalize. Austenitize: 1900-2000°F (1037-1093°C), hold time at temperature 30-60 minutes. Quench: Oil or positive pressure (4 bar minimum) to below 125°F (50°C), or salt quench to about 1000°F (540°C), then air cool to below 125°F (50°C). Temper: Twice at 400-1200°F (204-650°C), 2 hours minimum each time.
PROPRIETARY CRUCIBLE 154 CM Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CRUCIBLE 154 CM International Equivalent Materials
Showing 2 of 2 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 2 international equivalents?
See all 2 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 2Cross References
- 3Composition
- 6Mechanical Properties
- 14Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers