PROPRIETARY 154CM Stainless steels
Data updates
This material has 76 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 154CM Chemical Composition
Rolled Alloys, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY 154CM Physical Properties
Temperature
This material has 76 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 154CM Heat Treatments
- Annealing: Heat to 900°C (1650°F), hold 2 hours, slow cool no faster than 15°C (25°F) per hour to 650°C (1200°F), then furnace cool or cool in still air to room temperature. Can be cycle annealed by heating to 870°C (1600°F), hold 2 hours, cool to 704°C (1300°F), hold 4 hours, then air cool.
Stress Relieving Annealed Parts: Heat to 595–705°C (1100–1300°F), hold 2 hours, then furnace cool or cool in still air.
Hardened Parts: Heat to 15–30°C (25–50°F) below the original tempering temperature, hold 2 hours, then furnace cool or cool in still air.
Hardening Preheat: Heat to 760°C (1400°F), equalize.
Austenitize: Heat to 1037–1093°C (1900–2000°F), hold for 30–60 minutes.
Quench: Oil or positive pressure (minimum 4 bar) to below 50°C (125°F), or salt quench to about 540°C (1000°F), then air cool to below 50°C (125°F). Salt bath treatment, if practical, will ensure the maximum attainable toughness for a given hardening treatment.
Temper: Temper twice at 204–650°C (400–1200°F), for a minimum of 2 hours each time. Tempering at 425–600°C (800–1100°F) will result in sensitization, which causes a minor reduction in both corrosion resistance and toughness so this tempering range should be avoided.
PROPRIETARY 154CM Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY 154CM International Equivalent Materials
Showing 2 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 9Composition
- 55Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 5Total Suppliers