ASTM A 841 Grade G Class 9 Structural and constructional steels
Data updates
This material has 83 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 841 Grade G Class 9 Chemical Composition
A841/A841M: 2017 / Standard Specification for Steel Plates for Pressure Vessels, Produced by Thermo-Mechanical Control Process (TMCP)
Looking for full material performance data?
Free registration required • Instant access
ASTM A 841 Grade G Class 9 Physical Properties
Temperature
This material has 83 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 841 Grade G Class 9 Heat Treatments
- Plates may be formed at temperatures not exceeding 530°C (985°F). Except for the TMR-I-T process, the plates shall be cooled directly after rolling without being allowed to cool below 550°C (1025°F).Quenching hardening shall be initiated from a temperature within the range from 550°C to 810°C (1025°F to 1490°F). Subsequent to quenching, the plates shall be tempered within the range from 555°C to 625°C (1030°F to 1155°F), holding at that temperature for a minimum of 1.2 min ⁄mm of thickness but for not less than 15 min, and then cooling at a rate of not less than 165°C ⁄h (300°F ⁄h), either in air or by quenching in water, to ambient temperature. Prior to the tempering treatment, the plates may be subjected to an intermediate heat treatment consisting of heating to a temperature in the range from 640°C to 710°C (1185°F to 1310°F), holding at that temperature for a minimum of 2.4 min ⁄mm of thickness, but in no case less than 15 min, and then water-quenching to below 150°C (300°F) in the case of plate thicknesses of more
ASTM A 841 Grade G Class 9 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 841 Grade G Class 9 International Equivalent Materials
Showing 2 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 10Composition
- 8Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 24Joints
- -Coatings
- 34Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers