ASME SA-705 S35500 Stainless steels
Data updates
This material has 67 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SA-705 S35500 Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part A Ferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SA-705 S35500 Physical Properties
Temperature
This material has 67 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SA-705 S35500 Heat Treatments
- Solution treating: 1040 ± 15°C, quench, hold not less than 3h at -73°C or lower. Equalization and over-tempering treatment 775 ± 30°C for not less than 3h, cool to room temperature, heat to 580 ± 15°C for not less than 3h.
Aging treatment: H1000: 955°C for but not less than 10 min, but not more than 1h. Water quench. Cool to not higher than -73°C. Hold for not less than 3h. Temper 540°C, holding for not less than 3h.
ASME SA-705 S35500 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SA-705 S35500 International Equivalent Materials
Showing 12 of 26 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 26 international equivalents?
See all 26 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 26Cross References
- 9Composition
- 7Mechanical Properties
- 5Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 16Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers