CSN 1.0721 Structural and constructional steels
Data updates
This material has 788 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
CSN 1.0721 Chemical Composition
EN 10087: 1998 / Free-cutting steels - Technical delivery conditions for semi-finished products, hot-rolled bars and rods
Looking for full material performance data?
Free registration required • Instant access
CSN 1.0721 Physical Properties
Temperature
This material has 788 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
CSN 1.0721 Heat Treatments
- Carburizing: 880-980°C. The carburizing temperature will depend on the chemical composition of the steel, the mass of the product, and the carburizing medium. If the steels are direct hardened, in general, a temperature of 950°C is not exceeded. For special procedures, for example under vacuum, higher temperatures (for example 1 020 to 1 050°C) are not unusual;
Core-hardening: 880-920°C. When applying the single quench method, the steel is to be quenched from the carburizing temperature or a lower temperature. The lower hardening temperatures are in each case to be preferred, in particular when there is risk of distortion; Case-hardening: 780-820°C;
Quenching agent: water, oil, emulsion. The kind of quenching agent depends on, for example, the shape of the products, the cooling conditions and the amount of furnace filling;
Tempering: 150-200°C (1 h minimum).
CSN 1.0721 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
CSN 1.0721 International Equivalent Materials
Showing 15 of 400 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 400 international equivalents?
See all 400 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 400Cross References
- 21Composition
- 71Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 2Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 290Total Suppliers