PROPRIETARY EskyLos 2343 Tool steels
Data updates
This material has 201 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY EskyLos 2343 Chemical Composition
Lucchini RS, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY EskyLos 2343 Physical Properties
Temperature
This material has 201 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY EskyLos 2343 Heat Treatments
- Supplied in the annealed condition with hardness lower than 220 HB.
Soft annealing: at 850°C, heating max 50°C/h, soaking time minimum 120 min from when the temperature settles, cooling slow in the furnace.
Stress relieving at 650°C, heating max 100°C/h, soaking time minimum 120 min from when the temperature settles, cooling slow in the furnace. If the suggested temperature is lower than the tempering temperature, the stress relieving temperature will be 50°C lower than the tempering temperature previously applied.
Hardening: first pre-heating at 400°C, heating max 150°C/h, soaking time 60 min every 25 mm thickness or when (Ts-Tc)<90°C; second preheating at 600°C, heating max 150°C/h, soaking time 45 min every 25 mm thickness or or when (Ts-Tc)<90°C; third preheating at 800°C, heating max 150°C/h, soaking time 25 min every 25 mm thickness or when (Ts-Tc)<90°C;
Austenising at 980°C, heating >150°C/h, soaking time (x+39)/2 or 30 min from when (Ts-Tc)<15°C, cooling air, vacuum cooling, salt bath, oil. Tempering: the first temper at 580 °C, soaking time 0,8x+120, cooling at room temperature; the t of the second temper must be set on the basis of the required mechanical properties, and must be higher than the t applied for the first temper, soaking time 0,8x+120, cooling at room temperature; A third temper at a temperature of 30-50°C below the maximum temperature previously applied, soaking time 0,8x+180, slow cooling in the furnace up to 250°C, then at room temperature.
PROPRIETARY EskyLos 2343 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY EskyLos 2343 International Equivalent Materials
Showing 15 of 87 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 87 international equivalents?
See all 87 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 87Cross References
- 6Composition
- 10Mechanical Properties
- 11Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 84Total Suppliers