PROPRIETARY AerMet 100 Alloy Tool steels
Data updates
This material has 58 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY AerMet 100 Alloy Chemical Composition
Carpenter Technology Corporation, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY AerMet 100 Alloy Physical Properties
Temperature
This material has 58 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY AerMet 100 Alloy Heat Treatments
- Normalizing: heating to 899°C (1650°F) holding for one hour and air cooling to room temperature. Optimum softening for machining is obtained by following the 899°C (1650°F) normalize with a 16h 677°C (1250°F) overage anneal.
Annealing: softened by using a 677°C (1250°F) overage anneal for 16h. The optimum annealed hardness of 40 HRC maximum is obtained following this anneal.
Solution treatment: at a range 885°C ±14°C (1625°F ±25°F) for 1h.
Quenching: water quenching is not recommended; cooled from the solution treatment temperature to 66°C (150°F) in 1 to 2h to develop optimum properties. Individual sections larger than 50.8mm diameter or 25.4mm thick (plate) must be quenched with oil in order to obtain 66°C (150°F) in 1 to 2h. Individual sections up to 50.8mm diameter or 25.4mm thick (plate) will air cool to 66°C (150°F) in 1 to 2h. The cooling rate of the furnace load must be monitored by a thermocouple attached to the hottest spot in the load to ensure that the 2h cool to 66°C (150°F) is obtained.
Cold treatment: cooled to -73°C (-100°F) and held for 1 hour.
Straightening: a low temperature stress relief at 177/204°C (350/400°F) for 5 hours following the refrigeration operation will provide an optimal combination of ductility and yield strength.
Aging: at 482°C ±6°C (900°F ±10°F) for 5 hours; parts should never be aged at a temperature below 468°C (875°F).
PROPRIETARY AerMet 100 Alloy Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY AerMet 100 Alloy International Equivalent Materials
Showing 3 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 6Composition
- 10Mechanical Properties
- 25Physical Properties
- 1Heat Treatment
- 3Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- 3Fatigue
- 2Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers