ISO X 2 NiCrMoCu 25 20 5 Stainless steels
Data updates
This material has 303 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ISO X 2 NiCrMoCu 25 20 5 Chemical Composition
ISO 9328-5: 2018 / Steel plates and strips for pressure purposes - Technical delivery conditions - Part 5: Weldable fine grain steels, thermomechanically rolled
Looking for full material performance data?
Free registration required • Instant access
ISO X 2 NiCrMoCu 25 20 5 Physical Properties
Temperature
This material has 303 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ISO X 2 NiCrMoCu 25 20 5 Heat Treatments
- Quenching: 1050-1150°C, water quench or rapid air cool.
- Solutionized at 1050-1150°C, water quenched or air cooled
In the case of heat treatment in continuous furnaces, the temperature of the furnace atmosphere should normally be in the upper part of the given temperature range or even exceed it
In the case of heat treatment during processing after delivery, the lower part of the given solution temperature ranged is to be aimed for. If during hot working, the temperature was not below the specified lower limit of the solution temperature, 1020°C is sufficient for repeat heat treatments
ISO X 2 NiCrMoCu 25 20 5 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ISO X 2 NiCrMoCu 25 20 5 International Equivalent Materials
Showing 15 of 129 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 129 international equivalents?
See all 129 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 129Cross References
- 20Composition
- 34Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 6Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 109Total Suppliers