ISO Type A-4 Stainless steels
Data updates
This material has 286 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ISO Type A-4 Chemical Composition
ISO 683-13: 1986 / Heat-treatable steels, alloy steels and free-cutting steels - Part 13: Wrought stainless steels
Looking for full material performance data?
Free registration required • Instant access
ISO Type A-4 Physical Properties
Temperature
This material has 286 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ISO Type A-4 Heat Treatments
- In the case of heat treatment in the course of processing after delivery, the lower part of the given solution temperature range is to be striven for. If, in the course of heat treatment, the temperature was not below the specified lower limit of the solution temperature, the following temperatures are sufficient for repeat heat treatments: 980°C in the case of molybdenum-free steels, 1 000°C in the case of steels with Mo <= 3% , 1020°C in the case of steels with Mo > 3%.
Quenched at 1050 to 1150°C, cooled sufficiently rapid in water or air.
ISO Type A-4 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ISO Type A-4 International Equivalent Materials
Showing 15 of 131 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 131 international equivalents?
See all 131 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 131Cross References
- 10Composition
- 14Mechanical Properties
- 19Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 109Total Suppliers