PROPRIETARY Micro-Melt M42 Alloy Acier pour outils
Mises à jour des données
Ce matériau a 136 entrées de propriétés – seul un aperçu est visible ici.
Déverrouillez l’accès aux propriétés détaillées du matériau, notamment en température et dans différentes conditions.
Inscription gratuite requise • Accès instantané
PROPRIETARY Micro-Melt M42 Alloy Composition chimique
Carpenter Technology Corporation, Product Data Sheets,
Vous souhaitez voir toutes les données sur ce matériau ?
Inscription gratuite requise • Accès instantané
PROPRIETARY Micro-Melt M42 Alloy Propriétés physiques
Température
Ce matériau a 136 entrées de propriétés – seul un aperçu est visible ici.
Déverrouiller l’accès aux propriétés physiques à différentes températures et conditions.
Inscription gratuite requise • Accès instantané
PROPRIETARY Micro-Melt M42 Alloy Traitement thermique
- Annealing: heat slowly to 843/899°C (1550/1650°F), hold until the entire mass is heated through, and cool slowly (do not exceed 11°C [20°F] per hour) in the furnace to about 538°C (1000°F), after which the cooling rate may be increased. The expected hardness following this treatment is Brinell 235/269.
Hardening: preheat to 816/871°C (1500/1600°F) in a neutral salt bath. After thorough preheating, transfer to a salt bath with a temperature maintained at 1177/1204°C (2150/2200°F) and oil quench. Small sizes under about 25.4 mm (1") in diameter or delicate sections may be hardened by cooling in still air. It is also acceptable to quench in molten salt at temperatures of 538/593°C (1000/1100°F), equalizing for 5 minutes per inch followed by air cooling.
Stress Relieving: to relieve the strains of machining, heat slowly to 621/677°C (1150/1250°F), allow to equalize, then cool in still air.
Tempering: tools should be tempered immediately after the completion of the quench. The tempering temperature may be varied according to the desired hardness but is usually in the range of 538/566°C (1000/1050°F). Triple tempering is always suggested.
PROPRIETARY Micro-Melt M42 Alloy Matériaux équivalents internationaux
Affichage de 15 résultats sur 60.
Les catégories d'équivalence reflètent la comparaison de la composition chimique et des propriétés mécaniques — vérifiez toujours l'adéquation avec la spécification applicable à votre application.
Besoin de la liste complète des 60 équivalents internationaux ?
Consultez les 60 nuances équivalentes avec une cartographie détaillée par norme, producteur et catégorie d'équivalence.
Inscription gratuite requise • Accès instantané
Optimisez les choix de matériaux pour votre application - Réserver une démo
- 60Références croisées
- 10Composition
- -Propriétés mécaniques
- 5Propriétés physiques
- 1Traitement thermique
- -Métallographie
- -Usinabilité
- -Contrainte-Déformation
- -Formabilité
- -Fatigue
- -Rupture
- -Rampant
- -Assemblages
- -Revêtements
- -Dimensions
- -Tribologie
- -Corrosion
- -Vieillissement
- -Résistance aux intempéries
- -Irradiation
- 60Fournisseurs totaux