PROPRIETARY Micro-Melt M42 Alloy Aceros para herramientas
Actualizaciones de datos
Este material cuenta con 136 propiedades — aquí solo se muestra una parte.
Accede a todas las propiedades del material, incluyendo valores detallados según temperatura y condiciones.
Se requiere registro gratuito • Acceso inmediato
PROPRIETARY Micro-Melt M42 Alloy Composición química
Carpenter Technology Corporation, Product Data Sheets,
¿Buscas datos completos de desempeño de materiales?
Se requiere registro gratuito • Acceso inmediato
PROPRIETARY Micro-Melt M42 Alloy Propiedades físicas
Temperatura
Este material cuenta con 136 propiedades — aquí solo se muestra una parte.
Consulta propiedades físicas detalladas en distintas temperaturas y condiciones.
Se requiere registro gratuito • Acceso inmediato
PROPRIETARY Micro-Melt M42 Alloy Tratamiento Térmico
- Annealing: heat slowly to 843/899°C (1550/1650°F), hold until the entire mass is heated through, and cool slowly (do not exceed 11°C [20°F] per hour) in the furnace to about 538°C (1000°F), after which the cooling rate may be increased. The expected hardness following this treatment is Brinell 235/269.
Hardening: preheat to 816/871°C (1500/1600°F) in a neutral salt bath. After thorough preheating, transfer to a salt bath with a temperature maintained at 1177/1204°C (2150/2200°F) and oil quench. Small sizes under about 25.4 mm (1") in diameter or delicate sections may be hardened by cooling in still air. It is also acceptable to quench in molten salt at temperatures of 538/593°C (1000/1100°F), equalizing for 5 minutes per inch followed by air cooling.
Stress Relieving: to relieve the strains of machining, heat slowly to 621/677°C (1150/1250°F), allow to equalize, then cool in still air.
Tempering: tools should be tempered immediately after the completion of the quench. The tempering temperature may be varied according to the desired hardness but is usually in the range of 538/566°C (1000/1050°F). Triple tempering is always suggested.
PROPRIETARY Micro-Melt M42 Alloy Materiales equivalentes internacionales
Mostrando 15 de 60 resultados.
Las categorías de equivalencia reflejan la comparación de composición química y propiedades mecánicas — verifique siempre la idoneidad según la especificación aplicable a su aplicación.
¿Necesita la lista completa de 60 equivalentes internacionales?
Consulte los 60 grados equivalentes con mapeo detallado por norma, productor y categoría de equivalencia.
Se requiere registro gratuito • Acceso inmediato
Optimiza la selección de materiales para tu aplicación - Reservar una demo
- 60Referencias cruzadas
- 10Composición
- -Propiedades mecánicas
- 5Propiedades físicas
- 1Tratamiento térmico
- -Metalografía
- -Maquinabilidad
- -Esfuerzo-Deformación
- -Conformabilidad
- -Fatiga
- -Fractura
- -Bicho raro
- -Uniones
- -Revestimientos
- -Dimensiones
- -Tribología
- -Corrosión
- -Envejecimiento
- -Resistencia a la intemperie
- -Irradiación
- 60Proveedores Totales