UNI P-AC4GM-clad Aluminium Alloys
Data updates
This material has 61 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI P-AC4GM-clad Chemical Composition
UNI 3580: 1955 / Primary wrought aluminium-copper-magnesium-manganese clad alloy (Cu 4% - Mg 0.5% - Mn 0.5%)
Looking for full material performance data?
Free registration required • Instant access
UNI P-AC4GM-clad Physical Properties
Temperature
This material has 61 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI P-AC4GM-clad Heat Treatments
- R: Complete annealing at 380 - 420 °C for 2 - 4 hours; slow cooling in oven (max 20°C/h until 200 °C). TN: Water quenching (10 - 30°C) from 485 - 505°C, after preheating for 0.5 - 1 hour in salt-bath; natural ageing (max 50°C) for 48-96 hours; THN: As per TN, with ironing after tempering that produces a slight hardening;
UNI P-AC4GM-clad Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI P-AC4GM-clad International Equivalent Materials
Showing 3 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 9Composition
- 22Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 7Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers