SAE 222.0 Aluminium Alloys
Data updates
This material has 65 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE 222.0 Chemical Composition
SAE J452: 2018 / Chemical compositions, mechanical and physical properties of SAE aluminum casting alloys
Looking for full material performance data?
Free registration required • Instant access
SAE 222.0 Physical Properties
Temperature
This material has 65 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE 222.0 Heat Treatments
- Temper 0 (2)
Temper T551
Permanent Mold Castings
Precipitation Heat Treated at 171 ± 6°C (340 ± 10°F), 16-22 hours;
Temper T61
Sand Castings
Solution Heat Treated (1) at 510 ± 6°C (950 ± 10°F), 8-12 hours;
Precipitation Heat Treated at 154 ± 6°C (310 ± 10°F), 10-12 hours;
Temper T65
Permanent Mold Castings
Solution Heat Treated (1) at 510 ± 6°C (950 ± 10°F), 4-12 hours;
Precipitation Heat Treated at 171 ± 6°C (340 ± 10°F), 7-9 hours;
(1) Quench in water at 65 to 100°C (150 to 212°F) except as noted.
(2)Use air blast quench. - Solution heat treatment shall be at the temperature: 507°C (945°F), minimum soak time is 6 hours and Quenched;
Temper after Solution treatment shall be T4 and delay at room temperature.
Annealing at 427°C (800°F), minimum soak time is 1 hour; Air cooling;
Aging (precipitation heat treatment):
Condition before Aging W or T4;
Aging at 199°C (390°F), soak time is 10-12 hours;
Temper T61 after Aging.
SAE 222.0 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE 222.0 International Equivalent Materials
Showing 12 of 16 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 16 international equivalents?
See all 16 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 16Cross References
- 10Composition
- 7Mechanical Properties
- 22Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- 5Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- 1Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 2Total Suppliers