PROPRIETARY VK5E Tool steels
Data updates
This material has 225 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VK5E Chemical Composition
Villares Metals, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY VK5E Physical Properties
Temperature
This material has 225 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VK5E Heat Treatments
- Annealing: Soft annealing may be carried out by heating between 850 and 880°C for 2 hours, followed by slow cooling at 10/20°C per hour until 650°C and, then, by air cooling. In this treatment, the use of protective atmosphere is important to avoid surface decarburization.
Stress relieving: The indicated procedure is heating between 600 and 700°C and holding until complete homogenization, followed by slow cooling (air or furnace) at least down to 500°C.
Hardening and Tempering: Hardening (1190-1220°C) and Tempering (560°C). Hardening procedure must involve pre-heating at 400/500°C followed by other at 860/880°C. After pre-heating, austenitizing may be conducted, followed by quenching down to room temperature. A protective atmosphere is absolutely necessary. Three tempering treatments, of at least 2h, are required and after each one tools must cool to room temperature.
Surface treatments: If nitriding is applied, the treatment temperature should be lower than the tempering temperature, to avoid decrease of core hardness. It is important that, before all surface treatments, tools have clean surface (without oil or grease) and are free from grinding overheating.
PROPRIETARY VK5E Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY VK5E International Equivalent Materials
Showing 15 of 110 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 110 international equivalents?
See all 110 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 110Cross References
- 6Composition
- 3Mechanical Properties
- 4Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 100Total Suppliers