PROPRIETARY M35 Structural and constructional steels
Data updates
This material has 262 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY M35 Chemical Composition
IMS Group, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY M35 Physical Properties
Temperature
This material has 262 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY M35 Heat Treatments
- Annealing at 860 - 900°C, hold for 2h, furnace cooling by 10°C/h to 700°C, cooling in air. Stress relieving at 600 - 680°C, hold for at least 2h, cooling slowly to 500°C and then in air. Hardening: Initial slow preheating to 500 - 550°C, second preheating to 850 - 880°C, heat to temperature in the range 1200 - 1220°C and hold at temperature, cooling in oil or salt bath at 530 - 580°C. Tempering immediately after hardening at 530 - 580°C.
- Soft-annealing 850°C - 900°C / 1560°F - 1650°F, slow cooling 10°C / 18°F/h to 700°C / 1290°F. Stress relieving 600°C - 700°C / 1120°F - 1290°F, approx. 2 hours at temperature, slow cooling to 500°C / 930°F. Hardening with preheating in two steps 450°C - 500°C / 840°F - 930°F, 850°C - 900°C / 1560°F - 1650°F and austenitizing at 1050°C - 1220°C / 1920°F - 2230°F. Quenching to about 550°C / 1022°F then cool in air to hand warm. Tempering at 560°C / 1040°F or higher 2 times for at least 1 hour at full temperature is recommended.
PROPRIETARY M35 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY M35 International Equivalent Materials
Showing 15 of 116 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 116 international equivalents?
See all 116 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 116Cross References
- 12Composition
- 5Mechanical Properties
- 17Physical Properties
- 2Heat Treatment
- 3Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 107Total Suppliers