MS X6CrNiCu17-8-2 Stainless steels
Data updates
This material has 124 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MS X6CrNiCu17-8-2 Chemical Composition
MS 2317: 2010 / Stainless steels - Chemical Composition
Looking for full material performance data?
Free registration required • Instant access
MS X6CrNiCu17-8-2 Physical Properties
Temperature
This material has 124 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MS X6CrNiCu17-8-2 Heat Treatments
- Hot forming (air cooling): 1150-850°C; Solution annealing (water or rapid cooling with air): 1010-1150°C. If heat treatment is carried out in continuous furnace, the upper part of the range specified is usually preferred, or even exceeded. The lower end of the range specified for solution annealing should be aimed at for heat treatment that is part of further processing, otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1 000°C for steels with Mo contents up to 3% and a temperature of 1 020°C for steels with Mo contents exceeding 3%.
MS X6CrNiCu17-8-2 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MS X6CrNiCu17-8-2 International Equivalent Materials
Showing 15 of 51 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 51 international equivalents?
See all 51 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 51Cross References
- 16Composition
- 9Mechanical Properties
- 4Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 43Total Suppliers