DIN 1.4567 Stainless steels
Data updates
This material has 675 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN 1.4567 Chemical Composition
DIN 1654-5: 1989 / Cold heading and cold extruding steels; technical delivery conditions for stainless steels
Looking for full material performance data?
Free registration required • Instant access
DIN 1.4567 Physical Properties
Temperature
This material has 675 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN 1.4567 Heat Treatments
- (+AT) Solution annealed: 1000-1100°C, cooled sufficiently rapid in air or water.
- Hot forming: 1200-900°C, air cooling; Solution annealing (+AT): 1000-1100°C, water or air cooling. If heat treatment is carried out in a continuous furnace, the upper part of the range specified should usually be preferred, or even exceeded. The lower end of the range specified for solution annealing should be aimed at the heat treatment as part of further processing, because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as lower limit for Mo-free steels.
DIN 1.4567 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN 1.4567 International Equivalent Materials
Showing 15 of 211 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 211 international equivalents?
See all 211 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 211Cross References
- 53Composition
- 93Mechanical Properties
- 19Physical Properties
- 4Heat Treatment
- 1Metallography
- 1Machinability
- 14Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 156Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 123Total Suppliers