ASME 1.5415 Structural and constructional steels
Data updates
This material has 518 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME 1.5415 Chemical Composition
Flat products made of steels for pressure purposes - Part 2: Non-alloy and alloy steels with specified elevated temperature properties, EN 10028-2, 2017
Looking for full material performance data?
Free registration required • Instant access
ASME 1.5415 Physical Properties
Temperature
This material has 518 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME 1.5415 Heat Treatments
- Normalized (+N): 890 - 950°C; air cooling.
Normalizing includes: Normalizing Forming. Normalized Forming shall be carried out in a temperature range from 880 - 1000°C. - Normalizing at 890-950°C. When normalizing, after the required temperatures have been attained over the whole cross- section, no further holding is necessary and should be generally avoided.; Tempering at 590-650°C (in certain cases); Stress-relieving for 1h at 600°C and for 2h at 580°C
ASME 1.5415 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME 1.5415 International Equivalent Materials
Showing 15 of 84 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 84 international equivalents?
See all 84 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 84Cross References
- 32Composition
- 282Mechanical Properties
- 3Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- 56Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 58Total Suppliers