PROPRIETARY 9RU10 Stainless steels
Data updates
This material has 374 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 9RU10 Chemical Composition
Sandvik Materials Technology, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY 9RU10 Physical Properties
Temperature
This material has 374 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 9RU10 Heat Treatments
- Tempering at 480°C (900°F) for 1 hour. For wires tempering at 480°C (900°F) for 0.5-1 h. Batch tempering at 300°C (570°F) for 0.5-3 h.
- For maximum increase in mechanical strength, tempering should be carried out at 480°C (900°F) for 1 hour. It will give a significant increase in strength for initial tensile strengths above approximately 1300 MPa. This increase can be between 150-400 MPa and is higher the greater is the initial tensile strength. Because of its high structural stability in the precipitation hardened condition, the good spring properties are also retained at elevated temperatures, up to about 350°C (662°F).
PROPRIETARY 9RU10 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY 9RU10 International Equivalent Materials
Showing 15 of 120 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 120 international equivalents?
See all 120 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 120Cross References
- 16Composition
- 68Mechanical Properties
- 52Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 10Stress-Strain
- 2Formability
- 12Fatigue
- -Fracture
- -Creep
- 2Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 90Total Suppliers