PROPRIETARY BeyLos 2367 Tool steels
Data updates
This material has 38 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BeyLos 2367 Chemical Composition
Lucchini RS, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BeyLos 2367 Physical Properties
Temperature
This material has 38 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BeyLos 2367 Heat Treatments
- Normally supplied in the annealed condition with hardness values lower than 220 HB, if subjected to suitable hardening, it can reach a hardness of 52 HRc without affecting the toughness. Soft annealing: at 850°C, heating max 50°C/h, soaking time 120 min from when the temperature settles, cooling slow in the furnace. Stress relieving at 650°C, heating max 100°C/h, soaking time 120 min every 25 mm thickness, cooling slow in the furnace. If the suggested temperature is lower than the tempering temperature, the stress relieving temperature will be 50°C lower than the tempering temperature previously applied. Hardening: at 400°C (first pre-heating temperature), heating max 150 °C/h, soaking time 60 min every 25 mm thickness or when (Ts-Tc)<90°C; second pre-heating temperature at 600°C, heating max 150 °C/h, soaking time 45 min every 25 mm thickness or when (Ts-Tc)<90°C, third pre-heating temperature at 800°C, heating max 150 °C/h, soaking time 25 min every 25 mm thickness or when (Ts-Tc)<90°C. Austenising at 1050°C, heating > 150 °C/h, soaking time t=(x+39)/2 or 30min from when (Ts-Tc)<15°C, cooling in air, vacuum cooling, salt bath, water quench. First tempering temperature 580°C, soaking time t’=0,8x +120, cooling room temperature. Second tempering temperature set on the basis of the required mechanical properties, in any case higher than the temperature applied for the first temper, soaking time t’=0,8x +120, cooling room temperature. Third tempering temperature 30-50°C lower than the max temperature previously applied, soaking time t’=0,8x +180, cooling slow cooling in the furnace up to 250°C, then at room temperature.
PROPRIETARY BeyLos 2367 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BeyLos 2367 International Equivalent Materials
Showing 5 of 6 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 6 international equivalents?
See all 6 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 6Cross References
- 6Composition
- 10Mechanical Properties
- 11Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers