PROPRIETARY BÖHLER W500 Tool steels
Data updates
This material has 199 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER W500 Chemical Composition
Voestalpine Böhler Edelstahl GmbH & Co KG, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER W500 Physical Properties
Temperature
This material has 199 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER W500 Heat Treatments
- Annealing: 650-700°C (1202-1292°F); Slow controlled cooling in furnace at a rate of 10 to 20°C/hr (50 to 68°F/hr) down to approx. 600°C (1100°F), further cooling in air.
Stress relieving: 600-650°C (1112-1202°F); Slow cooling in furnace; intended to relieve stresses set up by extensive machining, or in complex shapes. After through heating, hold in natural atmosphere for 1 - 2 hours.
Hardening and tempering:
1. 830-870°C (1526-1598°F); oil Holding time after temperature equalization: 15 to 30 minutes. After hardening, tempering to the desired working hardness, see tempering chart.
2. 870-900°C (1598-1652°F); air, gas Holding time after temperature equalization: 15 to 30 minutes. After hardening, tempering to the desired working hardness, see tempering chart.
PROPRIETARY BÖHLER W500 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER W500 International Equivalent Materials
Showing 15 of 90 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 90 international equivalents?
See all 90 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 90Cross References
- 7Composition
- 11Mechanical Properties
- 16Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 72Total Suppliers