PROPRIETARY BÖHLER K100 Tool steels
Data updates
This material has 182 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K100 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER K100 Physical Properties
Temperature
This material has 182 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K100 Heat Treatments
- Annealing: 800 to 850°C (1472 to 1562°F), slow controlled cooling in furnace at a rate of 10 to 20 °C/hr (18 to 36 °F/hr) down to approximately 600°C (1112°F), further cooling in air.
Stress relieving: 650°C (1202°F), after through heating, hold in neutral atmosphere for 1-2 hours. Slow cooling in furnace, intended to relieve stresses caused by extensive machining or in complex shapes.
Hardening and Tempering: 940 to 970°C (1724 to 1778°F).
Quenching: Oil, salt bath (220 to 250°C or 500 to 550°C (428 to 482°F or 932 to 1022°F)), gas, compressed or still air if thickness does not exceed 25 mm (0.98 inch) and if hardening temperature is on the upper side of the range.
Holding time after temperature equalization: 15 to 30 minutes.
After hardening, tempering to the desired working hardness according to the tempering chart.
PROPRIETARY BÖHLER K100 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER K100 International Equivalent Materials
Showing 15 of 81 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 81 international equivalents?
See all 81 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 81Cross References
- 4Composition
- 13Mechanical Properties
- 15Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 65Total Suppliers