PROPRIETARY Uddeholm Vanadis 23 SuperClean Tool steels
Data updates
This material has 153 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 23 SuperClean Chemical Composition
Uddeholms AB, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 23 SuperClean Physical Properties
Temperature
This material has 153 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 23 SuperClean Heat Treatments
- Soft annealing:
Protect the steel and heat through to 850-900°C (1560-1650°F). Then cool in the furnace at 10°C/h (20°F/h) to 700°C (1290°F), then freely in air;
Stress relieving:
After rough machining the tool should be heated through to 600-700°C (1110-1290°F), holding time 2 hr. Cool slowly to 500°C (930°F), then freely in air;
Hardening:
Preheating temperature: 450-500°C (840-930°F) and 850-900°C (1560-1650°F). Austenitizing temperature: 1050-1180°C (1920-2160°F) according to the desired final hardness;
Quenching media: Vacuum furnace with high speed gas at sufficient overpressure (2-5 bar), Martempering bath or fluidized bed at approx. 550°C (1020°F), Forced air/gas (Quenching should be continued until the temperature of the tool reaches approx. 50°C (120°F). The tool should then be tempered immediately; For applications where maximum toughness is required use a martempering bath or a furnace with sufficient overpressure.)
Tempering:
For cold work applications tempering should always be carried out at 560°C (1040°F) irrespective of the austenitizing temperature. Temper three times for one hour at full temperature. The tool should be cooled to room temperature between the tempers. The retained austenite content will be less than 1% after this tempering cycle.
Sub-zero treatment: For materials that require maximum dimensional stability, immediately after quenching the piece should be sub-zero treated -70 to -80°C (-95 to -110°F), soaking for 1-3 h and followed by tempering. - Austenitizing temperature 1080°C (1980°F). Holding time 30 minutes.
PROPRIETARY Uddeholm Vanadis 23 SuperClean Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 23 SuperClean International Equivalent Materials
Showing 15 of 68 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 68 international equivalents?
See all 68 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 68Cross References
- 5Composition
- 7Mechanical Properties
- 21Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 50Total Suppliers