PROPRIETARY VC 140 Stainless steels
Data updates
This material has 425 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VC 140 Chemical Composition
Villares Metals, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY VC 140 Physical Properties
Temperature
This material has 425 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY VC 140 Heat Treatments
- Forging: Heating to 1100 - 1200°C, keep at temperature until complete homogenization and start forging. Do not forge below 760°C. In case of repression, finish the work between 800 and 850°C. Cool slowly.
Annealing: For lower hardness, it should be heated to 840 - 900°C and cooled slowly in the oven. To improve machinability, it is recommended to heat to 750 - 790°C and air-cool.
Quenching: Heating slowly to 950 - 1000°C, keep at temperature for about half an hour and cool in oil. Large section pieces must be preheated to around 700°C and then brought to the tempering temperature. For small parts, cooling can be done with blown air.
Tempering: The tempering temperature is determined by the desired mechanical characteristics. The range between 420 and 600°C should be avoided, as tempering carried out between these temperatures tends to produce brittleness and a sharp drop in corrosion resistance.
PROPRIETARY VC 140 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY VC 140 International Equivalent Materials
Showing 15 of 264 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 264 international equivalents?
See all 264 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 264Cross References
- 2Composition
- 1Mechanical Properties
- 3Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 152Total Suppliers