PROPRIETARY CarTech Invar 36 Alloy Structural and constructional steels
Data updates
This material has 89 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CarTech Invar 36 Alloy Chemical Composition
Carpenter Technology Corporation, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CarTech Invar 36 Alloy Physical Properties
Temperature
This material has 89 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CarTech Invar 36 Alloy Heat Treatments
- To assure optimal dimensional stability, heat to 815°C (1500°F), hold at heat for 30 minutes per inch of thickness, water quench, reheat to 315°C (600°F) holding one hour at heat, then air cool.
To promote temporal stability (when necessary), material has been aged for 24 to 48 hours at 200°F (93°C).
Annealing: Heat to 790°C (1450°F) and hold at heat 30 minutes per inch of thickness, then air cool. Heating to temperatures above 538°C (1000°F) relieves the presence of cold work stresses. The higher the temperature, the lower the annealed hardness.
Forging temperature of 1100-1180°C (2000-2150°F) is preferred.
PROPRIETARY CarTech Invar 36 Alloy Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CarTech Invar 36 Alloy International Equivalent Materials
Showing 15 of 27 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 27 international equivalents?
See all 27 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 27Cross References
- 5Composition
- 18Mechanical Properties
- 16Physical Properties
- 1Heat Treatment
- -Metallography
- 1Machinability
- 3Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 18Total Suppliers