ASTM A 353 Structural and constructional steels
Data updates
This material has 365 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 353 Chemical Composition
A353/A353M: 2017 / Pressure Vessel Plates, Alloy Steel, Double-Normalized and Tempered 9 % Nickel
Looking for full material performance data?
Free registration required • Instant access
ASTM A 353 Physical Properties
Temperature
This material has 365 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 353 Heat Treatments
- First Normalizing Treatment - Heat the plate to a uniform temperature of 900 ± 15°C [1650 ± 25°F], hold at that temperature for a minimum of 2.4 min/mm [1 h/in.] of thickness, but in no case less than 15 min, and cool in air.
Second Normalizing Treatment - Reheat the plate to a uniform temperature of 790 ± 15°C [1450 ± 25°F], hold at that temperature for a minimum of 2.4 min/mm [1 h/in.] of thickness, but in no case less than 15 min, and cool in air.
Tempering Treatment - Reheat the plate to a uniform temperature within the range from 565 to 605°C [1050 to 1125°F], hold within that temperature range for a minimum of 2.4 min/mm [1 h/in.] of thickness, but in no case less than 15 min, and cool in air or water quench at a rate not less than 165°C/h [300°F/h].
ASTM A 353 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 353 International Equivalent Materials
Showing 15 of 177 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 177 international equivalents?
See all 177 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 177Cross References
- 6Composition
- 5Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 7Joints
- -Coatings
- 34Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- 2Irradiation
- 130Total Suppliers