UNI 60 SiCr 8 Structural and constructional steels
Data updates
This material has 157 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI 60 SiCr 8 Chemical Composition
UNI 3545: 1980 / Hot rolled special alloyed steel finished products, bars and wire rod, for quenched and tempered springs. Qualities, requirements and tests
Looking for full material performance data?
Free registration required • Instant access
UNI 60 SiCr 8 Physical Properties
Temperature
This material has 157 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI 60 SiCr 8 Heat Treatments
- This material is normally supplied in the annealed or normalized condition. The following temperatures are given in the specification as guidelines. Anneal at 640 to 700°C. Normalize at 860°C and air cool. Except for the Brinell hardness values, the values shown in the mechanical properties table apply to longitudinal testing of 10mm diameter test pieces subjected to the following quench and temper reference heat treatment (Q + T): Harden by oil quenching from 850°C +/- 10°C, after holding at temperature for a minimum of 1/2 hour, and temper at 480°C +/- 20°C for a minimum of 1 hour. The final heat treatment of springs may be carried out as follows (these are guideline temperatures only): Harden by oil quenching from 830 to 860°C. Temper at 400 to 450°C.
UNI 60 SiCr 8 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI 60 SiCr 8 International Equivalent Materials
Showing 15 of 77 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 77 international equivalents?
See all 77 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 77Cross References
- 6Composition
- 5Mechanical Properties
- 5Physical Properties
- 5Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 58Total Suppliers