DIN 1.8983 Structural and constructional steels
Data updates
This material has 2363 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN 1.8983 Chemical Composition
EN 10137-2: 1995 / Plates and wide flats made of high yield strength structural steels in the quenched and tempered or precipitation hardened conditions - Part 2: Delivery conditions for quenched and tempered steels
Looking for full material performance data?
Free registration required • Instant access
DIN 1.8983 Physical Properties
Temperature
This material has 2363 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN 1.8983 Heat Treatments
- Hardening from hot forming temperature from 900 to 950°C and cooling in water; Tempering from 600-680°C, cooling in air; Stress relieving: at 530-580°C, for t <= 15.00 mm, duration 15min, for 15.00 < t <= 30.00 mm, duration 30 min. and for t > 30.00 mm about 60 min. and cooling in air.
- If, due to regulations or for constructional reasons, stress relief annealing is necessary, it should be carried out at 530-580°C. If, in special cases, a higher temperature is to be used, the temperature must be 30°C lower than the actual tempering temperature, with a holding time of no more than 60 minutes.
DIN 1.8983 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN 1.8983 International Equivalent Materials
Showing 15 of 1317 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1317 international equivalents?
See all 1317 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1317Cross References
- 68Composition
- 52Mechanical Properties
- 4Physical Properties
- 2Heat Treatment
- 1Metallography
- -Machinability
- -Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- -Creep
- 23Joints
- -Coatings
- 32Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 863Total Suppliers