DTD 5192 Aceros estructurales y de construcción
Actualizaciones de datos
Este material cuenta con 28 propiedades — aquí solo se muestra una parte.
Accede a todas las propiedades del material, incluyendo valores detallados según temperatura y condiciones.
Se requiere registro gratuito • Acceso inmediato
DTD 5192 Composición química
D.T.D. 5192: 1967 / Acero al níquel - cromo - molibdeno - vanadio (190 kgf/mm^2) (refundido al vacío: Sección transversal límite 100 mm)
¿Buscas datos completos de desempeño de materiales?
Se requiere registro gratuito • Acceso inmediato
DTD 5192 Propiedades físicas
Temperatura
Este material cuenta con 28 propiedades — aquí solo se muestra una parte.
Consulta propiedades físicas detalladas en distintas temperaturas y condiciones.
Se requiere registro gratuito • Acceso inmediato
DTD 5192 Tratamiento Térmico
- Softening treatment:
- Heat at a temperature between 960°C and 980°C, furnace cool to a temperature of 660°C, hold for not less than 48 hours and cool in still air.
- Rolled bars. heat at a temperature between 800°C and 820°C, cool in the furnace at a rate not exceeding 15°C per hour down to a temperature below 550°C and then cool in still air.
Final heat treatment:
Hardening.
(a) Pre-heat as necessary at a temperature between 600°C and 650°C.
(b) For limiting ruling sections up to 25 mm (1 in). Heat at a temperature between 910°C and 930°C and cool in air or quench in oil.
(c) For limiting ruling sections of 25 mm (1 in) and above. Heat at a temperature between 910°C and 930°C and quench in oil.
Sub-zero treat for 2 hours minimum at a temperature below -70°C. The cooling rate, over the range -40°C to -70°C shall not exceed 25°C per hour.
Temper by heating at a temperature in excess of 300°C.
DTD 5192 Propiedades mecánicas
Temperatura
¿Buscas información completa sobre propiedades mecánicas para tomar la mejor decisión?
Obtén información completa sobre resistencia, dureza, fatiga y más.
Se requiere registro gratuito • Acceso inmediato
DTD 5192 Materiales Internacionales Equivalentes
Mostrando 4 de 4 resultados.
Las categorías de equivalencia reflejan comparaciones de composición química y propiedades mecánicas; siempre verifique la idoneidad del material según la especificación aplicable a su aplicación.
¿Necesita la lista completa de los 4 internacionales equivalentes?
Consulte los grados 4 equivalentes con el detalle completo de correspondencias por norma, fabricante y categoría de equivalencia.
Se requiere registro gratuito • Acceso inmediato
Optimiza la selección de materiales para tu aplicación - Reservar una demo
- 4Referencias cruzadas
- 9Composición
- 11Propiedades mecánicas
- 3Propiedades físicas
- 1Tratamiento térmico
- -Metalografía
- -Maquinabilidad
- -Esfuerzo-Deformación
- -Conformabilidad
- -Fatiga
- -Fractura
- -Bicho raro
- -Uniones
- -Revestimientos
- -Dimensiones
- -Tribología
- -Corrosión
- -Envejecimiento
- -Resistencia a la intemperie
- -Irradiación
- -Proveedores Totales