UNI P-AlCu4.4SiMnMg-clad Aluminium Alloys
Data updates
This material has 52 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI P-AlCu4.4SiMnMg-clad Chemical Composition
UNI SPERIMENTALE 3582: 1955 / Primary wrought aluminium-copper-silicium-manganese-magnesium-plated alloy (Cu 4.4% - Si 0.8% - Mn 0.8% - Mg 0.4%)
Looking for full material performance data?
Free registration required • Instant access
UNI P-AlCu4.4SiMnMg-clad Physical Properties
Temperature
This material has 52 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI P-AlCu4.4SiMnMg-clad Heat Treatments
- R: Complete annealing at 390 - 420 °C for 2 - 4 hours with slow cooling in oven (max 20°C/h until 250 °C); TN: Water quenching (10 - 30°C) from 490 - 505°C, after preheating for 0.5 - 1 hour in salt-bath; natural ageing (max 50°C) for 48 - 96 hours; THN: as per TN, with ironing after tempering that produces a slight hardening; TA: Water quenching (10 - 30°C) from 490 - 505°C, after preheating for 0.5 - 1 hour in salt bath; artificial ageing at 165 - 185°C for 8 - 12 hours; Hot working range: 260 - 480°C;
UNI P-AlCu4.4SiMnMg-clad Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI P-AlCu4.4SiMnMg-clad International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 10Composition
- 19Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 6Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers