NBR 6351 Aluminium Alloys
Data updates
This material has 266 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
NBR 6351 Chemical Composition
NBR 15197: 2011 / Aluminium alloys - Sheets, shapes and rivets for van body - Requirements
Looking for full material performance data?
Free registration required • Instant access
NBR 6351 Physical Properties
Temperature
This material has 266 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
NBR 6351 Heat Treatments
- Recommended homogenization treatment at 530-570 (+/- 10°C) The tolerance range of the selected treatment temperature should be used when the table of temperature variation range is greater than 20°C. 4h treatment time refers to the time when the core material should remain on the set temperature. This time should be adjusted according to the size and load characteristics to be treated and the homogenizing furnace. In this time, it should be added that the time required for all furnace data points indicating the lower limit of the treatment group (recovery time) for any load mass reaches that temperature. These times are determined based on thermal surveys of equipment and size of specific load. Higher temperatures for the materials to be solubilized in a press and lower for materials for solu-bilization in the oven.
NBR 6351 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
NBR 6351 International Equivalent Materials
Showing 15 of 124 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 124 international equivalents?
See all 124 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 124Cross References
- 70Composition
- 60Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- 6Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 2Total Suppliers