SAE 4880 Copper Alloys
Data updates
This material has 469 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE 4880 Chemical Composition
SAE AMS 4880E: 2025 / Aluminum Bronze Alloy, Centrifugal and Continuous-Cast Castings 81.5Cu - 10.3Al - 5.0Ni - 2.8Fe Quench Hardened and Temper Annealed (TQ50)
Looking for full material performance data?
Free registration required • Instant access
SAE 4880 Physical Properties
Temperature
This material has 469 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE 4880 Heat Treatments
- Quench Hardening: heat to a temperature within the range 871 to 927°C (1600 to 1700°F), hold at the selected temperature within ± 14°C (± 25°F) for not less than two hours, and quench in water.
Temper Annealing: heat to a temperature within the range 593 to 649°C (1100 to 1200°F), hold at the selected temperature within ± 8°C (± 15°F) for not less than two hours, and cool in air to room temperature.
SAE 4880 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE 4880 International Equivalent Materials
Showing 3 of 9 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 9 international equivalents?
See all 9 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 9Cross References
- 7Composition
- 16Mechanical Properties
- 9Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- 424Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers