UNI G-A3FeGN Aluminium Alloys
Data updates
This material has 61 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI G-A3FeGN Chemical Composition
UNI 3046: 1950 / Primary nickel-magnesium-iron-copper- aluminium alloy for castings (Cu 3% - Fe 1.5% - Si 0.7% - Mg 0.6% - Ni 0.6% - Ti 0.15%)
Looking for full material performance data?
Free registration required • Instant access
UNI G-A3FeGN Physical Properties
Temperature
This material has 61 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI G-A3FeGN Heat Treatments
- Annealed at 320-360°C for 4-8h; Hardened in hot water (60-100°C) from 520-530°C after preheating for 4-18h; Artificially aged at 150-175°C for 8-20h; Stabilized at 230°C for 2h. Optimal casting range in both sand and permanent mould is 680-760°C.
UNI G-A3FeGN Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI G-A3FeGN International Equivalent Materials
Showing 2 of 2 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 2 international equivalents?
See all 2 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 2Cross References
- 10Composition
- 28Mechanical Properties
- 13Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 7Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers