UNI G-AS5CG Aluminium Alloys
Data updates
This material has 93 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI G-AS5CG Chemical Composition
UNI SPERIMENTALE 3600: 1955 / Primary aluminium-silicon-copper- magnesium alloy for castings (Si 5%, Cu 1.3%, Mg 0.5%)
Looking for full material performance data?
Free registration required • Instant access
UNI G-AS5CG Physical Properties
Temperature
This material has 93 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI G-AS5CG Heat Treatments
- R: Annealing at 350 - 390°C for 4 - 8 hours. T: Tempering in hot water from 510 - 530°C after preheating for at least 12 hours for sand castings and 8 hours for permanent mould castings. A: Artificial ageing at 150 - 160°C for 4 hours (A 15,5/4) or 8 hours (A 15,5/8) at 165 - 175°C, for 16 hours (A 15,17/16), depending on the required mechanical properties.
UNI G-AS5CG Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI G-AS5CG International Equivalent Materials
Showing 15 of 35 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 35 international equivalents?
See all 35 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 35Cross References
- 11Composition
- 18Mechanical Properties
- 12Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 6Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 10Total Suppliers