UNI G-AlZn5MgFe Aluminium Alloys
Data updates
This material has 127 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI G-AlZn5MgFe Chemical Composition
UNI SPERIMENTALE 3602: 1955 / Primary aluminium-zinc-magnesium-iron- titanium alloy for castings (Zn 5%, Mg 0.6%, Fe 1%, Ti 0.2%)
Looking for full material performance data?
Free registration required • Instant access
UNI G-AlZn5MgFe Physical Properties
Temperature
This material has 127 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI G-AlZn5MgFe Heat Treatments
- The alloy has high hardenability when cast in sand or permanent mould (Ts, Tc) and therefore it is not needed to include a solution treatment. N: Natural ageing within 20 days; A: Artificial ageing at 100 - 120°C for nearly 30 hours, to be used when it is required a fast hardening of the casting. In the case where the tempering effect has not been satisfactory (big sand castings), it is possible to complete a full tempering cycle from 450°C after preheating for 2 - 6 hours and ageing.
UNI G-AlZn5MgFe Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI G-AlZn5MgFe International Equivalent Materials
Showing 14 of 54 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 54 international equivalents?
See all 54 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 54Cross References
- 10Composition
- 6Mechanical Properties
- 12Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 42Total Suppliers