SAE 2117 Aluminium Alloys
Data updates
This material has 175 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE 2117 Chemical Composition
SAE J454: 1991 / General Data on Wrought Aluminum Alloys
Looking for full material performance data?
Free registration required • Instant access
SAE 2117 Physical Properties
Temperature
This material has 175 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE 2117 Heat Treatments
- Solution heat treating at 502°C for all forms.
Solution heat treating soaking times and maximum quench delay times is on specifications.
Full anneal: At 399-427°C, soaking time is minimum 1h (soak times listed are for up to 13 mm maximum thickness. Add 0.5 hour for each additional 13 mm of product or nested stack thickness or fraction thereof over 13 mm), cooling in furnace (furnace cool at 28°C degrees per hour maximum, to 260°C, air cool to room temperature or furnace cool at 28°C degrees per hour maximum, to 232°C, hold at 232°C for 6 hours, furnace or air cool to room temperature). Stress relief: At 333-349°C, soaking time is minimum 0.5h (soak times listed are for up to 13 mm maximum thickness. Add 0.5 hour for each additional 13 mm of product or nested stack thickness or fraction thereof over 13 mm), cooling in air. - Annealing: Soak for 2 to 3 hours at 404°C (760°F); cool at rate of 28°C (50°F) per hour or slower to 260°C (500°F ); further cooling rate optional.
Solution heat treating temperature (for wire, rod, bar): 496-510°C (925- 950°F) , followed by an air cool and quenched.
SAE 2117 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE 2117 International Equivalent Materials
Showing 15 of 90 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 90 international equivalents?
See all 90 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 90Cross References
- 10Composition
- 8Mechanical Properties
- 4Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- 1Formability
- 4Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- 10Ageing
- -Weatherability
- -Irradiation
- 44Total Suppliers