PROPRIETARY Stellar TS700 Tool steels
Data updates
This material has 40 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Stellar TS700 Chemical Composition
Aubert & Duval, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Stellar TS700 Physical Properties
Temperature
This material has 40 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Stellar TS700 Heat Treatments
- Stress relieving will reduce stresses but will also cause hardening if done at over 400°C, which can be undesirable if post machining is to be done.
Solution treatment: by heating to 1050°C-1070°C with a preheating step and quenching in oil or using high pressure gas. Age at 600-700°C for 4 hours to reach the desired hardness.
Inter-critical heat treatment: The inter-critical heat treatment with soaking between 830-845°C transforms remaining austenite grains to martensite without causing grain growth. This heat treatment gives a better ductility at the cost of a re-duced maximum operating temperature.
Solution treatment I: 1050°C/30min/Quench
Solution treatment II: 840°/30min/Air
Aging I: 650°C/4h
Aging II: 675°C/4h
Aging III: 610°C/ 4h /Air
PROPRIETARY Stellar TS700 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Stellar TS700 International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 6Composition
- 25Mechanical Properties
- 5Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 2Total Suppliers