ASTM A 564 S11100 Stainless steels
Data updates
This material has 67 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 564 S11100 Chemical Composition
A564/A564M: 2025 / Standard Specification for Hot-Rolled and Cold-Finished Age-Hardening Stainless Steel Bars and Shapes
Looking for full material performance data?
Free registration required • Instant access
ASTM A 564 S11100 Physical Properties
Temperature
This material has 67 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 564 S11100 Heat Treatments
- Solution treated at 840 ± 14°C (1545 ± 25°F), quenched in oil or water, held for min. of 8 h at -73°C (-100°F), air warmed. Required hold time at -73°C (-100°F) is not mandatory if product is t < 51 mm.
Hardening:
Time refers to minimum time material is at temperature and may be extended to obtain required ductility properties.
Unless otherwise noted, temperatures shown are suggested temperatures and may be varied to obtain required tensile properties.
Intermediate temperatures must meet the ductility requirements of the next highest suggested hardening or aging temperature, or both.
When air cooling is specified, gases other than air may be used.
H900: Heated at 480°C (900°F), held for between 4h and 8h, cooled in air or quenched in oil or water.
H950: Heated at 510°C (950°F), held for 8h, cooled in air or quenched in oil or water.
H1000: Heated at 540°C (1000°F), held for 8h, cooled in air or quenched in oil or water.
ASTM A 564 S11100 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 564 S11100 International Equivalent Materials
Showing 4 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 11Composition
- 32Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 16Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers