PROPRIETARY CHRONIFER M-17C Stainless steels
Data updates
This material has 345 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17C Chemical Composition
L. Klein SA, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17C Physical Properties
Temperature
This material has 345 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17C Heat Treatments
- Forming. Warm: 950 – 1100 °C, preferably > 1020°C, slow cooling. Slow heating up to 850°C, then faster up tot he forming temperature. Cold: Feasible after an annealing 750 – 825 °C, slow cooling. Annealing. Soft anneal: 780 – 840°C, holding time 2-4h, slow furnace cooling 30°C/h to 600°C. Intermediary soft anneal during cold deformation: 600 – 680°C, air cooling. Minimum reduction: = 10 – 15%, to avoid an excessive grain growth. Quenching. Primary quench, oil, or rapid cooling in air or gas: 1000-1050°C. Optional: secondary quench by sub-zero cooling. Recommendation: To obtain the best efficiency, this secondary quench must be made without delay after the primary one. -20 down to -80°C/12 – 48h, preferably -80°C/12 – 24 Or cryo-treatment (deep cryo-cooling): -196°C/6 – 12h, progressive or step by step cooling to avoid a possible cracking. Tempering. According to needs. Not recommended temperature range: 400 – 580°C (brittleness range). Not advisable because of the increased risk of intergranular corrosion
PROPRIETARY CHRONIFER M-17C Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17C International Equivalent Materials
Showing 15 of 185 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 185 international equivalents?
See all 185 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 185Cross References
- 7Composition
- 4Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 133Total Suppliers