PROPRIETARY CHRONIFER M-17A Stainless steels
Data updates
This material has 179 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17A Chemical Composition
L. Klein SA, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17A Physical Properties
Temperature
This material has 179 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17A Heat Treatments
- Forming. Warm: 950 – 1200°C, preferably > 1020°C, slow cooling. Normal heating up to 760°C, then slow heating up to the preferable the forming temperature 1040-1200°C. Not recommended below 925°C. Cold: Can be made but difficult Intermediary anneals: 750 – 825 °C, slow cooling UTS after annealing: ˜ 750 MPa. Annealing. Soft anneal: • 845 – 870°C, holding time 2 - 4h, very slow furnace cooling down to 600°C. Intermediary annealing during cold working: 600 – 680°C, air cooling. Recommended minimum cold reduction before annealing = 10 – 15%, this to prevent a possible too strong grain growth. Quenching. Primary quenching: 1000 – 1030°C, oil or air. Optional: secondary quench by sub-zero cooling Recommendation: To obtain the best efficiency, this secondary quench must be made without delay after the primary one. -20 down to -80°C/12 – 48h, preferably -80°C/12 – 24 Or cryo-treatment (deep cryo-cooling): -196°C/6 – 12h, progressive or step by step cooling, to avoid a possible cracking. Tempering. According to needs. Not recommended temperature range: 400 – 580°C (brittleness range). Not advisable because of the increased risk of intergranular corrosion.
PROPRIETARY CHRONIFER M-17A Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CHRONIFER M-17A International Equivalent Materials
Showing 15 of 91 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 91 international equivalents?
See all 91 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 91Cross References
- 8Composition
- 2Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 62Total Suppliers