PROPRIETARY CHRONIFER Labor M-Plus Stainless steels
Data updates
This material has 85 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER Labor M-Plus Chemical Composition
L. Klein SA, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY CHRONIFER Labor M-Plus Physical Properties
Temperature
This material has 85 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY CHRONIFER Labor M-Plus Heat Treatments
- Forming. Warm: Forging: 1150 – 980°C, not recommended below 980°C. Soft annealing: 780 – 830°C, slow cooling 30°C/h bis 600°C, then in air. Sub-critical annealing: 650 – 760°C, air cooling; Intermediate annealing during cold working: preferably 650 - 680°C, air cooling; Primary quench, oil, or rapid cooling in air or gas: 1000-1050°C. Optional: secondary quench by sub-zero cooling. Recommendation: To obtain the best efficiency, this secondary quench must be made without delay after the primary one. -20 down to -80°C/12 – 48h, preferably -80°C/12 – 24. Or cryo-treatment (deep cryo-cooling): -196°C/6 – 12h, progressive or step by step cooling to avoid a possible cracking. Tempering according to needs. The temperature range 400 – 580°C should be avoided because of the increased risk of brittleness and reduction of the corrosion resistance.
PROPRIETARY CHRONIFER Labor M-Plus Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY CHRONIFER Labor M-Plus International Equivalent Materials
Showing 15 of 34 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 34 international equivalents?
See all 34 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 34Cross References
- 8Composition
- 4Mechanical Properties
- 16Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 21Total Suppliers